SOUNDCORE LIBERTY NEO BENUTZERHANDBUCH Pdf-Herunterladen (2024)

FAQs

How to reset Soundcore Liberty Neo? ›

Place the earbuds in the charging case and leave the case open. Press and hold the reset button on the charging case for 10 seconds until the LED indicators on the charging case start to scroll and then stay on for 5 seconds. At this time, your earbuds have been successfully reset.

Step 1: Place both life note and life note L in the case. Step 2: Hold buds for 10 sec (within case) until the red light flashes for 3 times. Step 3: Pick the earbuds ( note life and note life L ) together from case. Step 4: Pair with a earbud and wait for it to connect with the other.

You can answer a call with your soundcore liberty 4 simply by double taping on any of the earbuds. For most earbuds, the touch sensor allows you to take a call with just a tap on either the right or left earbud.

Be sure the battery is not depleted. For more info see, Checking the remaining battery charge and Charging your headphones. Reboot the Bluetooth® device. Electronics, such as cell phones, tablets or computers, might need to be reset on occasion to correct minor issues.

Press the bluetooth button on both speakers at the same time for 5-8seconds until the bluetooth light turns flash white. 3. Release the bluetooth button for both speakers and then 2 speakers will pair with each other automatically in 5s.

The soundcore app offers unique features for each of the supported soundcore devices and allows you to personalize and optimize your listening experience.

IPX7 protection: sweat guard protection creates a watertight barrier for the wireless earbuds against rain and sweat. It even resists water from the tap when you're washing away the sweat after a hardcore workout.

Does Soundcore Liberty Neo have a mic? ›

Built-In Microphone: For clear, hands-free calls.

You can answer and end calls with the earbuds' onboard controls. If you're looking for buds with more call-centric features, consider the Jabra Elite 7 Pro True Wireless instead.

The Anker Soundcore Life Q20 Wireless are the best headphones for calls in the cheap range we've tested. These headphones are a good low-cost alternative to the JBL Tune 760NC Wireless since they have a similarly comfortable fit and a good overall mic performance.

Press the "NC" button to cycle between the modes. The order is Noise Cancelling (default) > Transparency > Normal. Manually switch between the three modes and customize the level of noise cancellation and transparency. Note: On the soundcore app, you can also customize the button functions by going to "Controls.”

Here are the steps: 1) Place the earbuds in the charging case and leave the lid open. 2) Press and hold the button on the case for 10 seconds until the LED indicators inside flash 3 times quickly. When the LEDs start flashing fast, it confirms that the reset was successful and the earbuds have entered pairing mode.

Put the earbuds into the charging case and close for 10 seconds, then open the charging case to try pairing again. If that doesn't work, try the following: 1- Make sure your headphones are fully charged. 2- Make sure that the volume is turned up on both the headphone and the connected device.